Demonstration Mode
The GTX Raster CAD and GTX Image CAD series programs may be
installed and operated, even without a purchased license. The demonstration
mode installation procedure for the program is the same as the licensed mode,
except for the process of installing and activating a license. The following
choices provided during the installation will cause the programs to operate in
demonstration mode.
GTXRaster CAD Series Install - License
Mode Dialog:
GTXImage CAD Series Install - License
Mode (and other options):
Note #1: A lengthy delay in the startup of the GTX program is
normal if a HASP hardware key is not connected and the variable DEMOMODE= is
set to NO. To resolve this, acquire a HASP hardware key from GTX or set the
DEMOMODE= variable to YES.
Note #2: After the GTX program has been installed, the product version and
'DEMO' mode status may be manually altered by editing variable values in the
GTXRAST.CFG file. This file is to be found in the main GTX Image CAD or Raster
CAD program folder.
For the GTXRaster CAD Series, the controlling variables are as follows:
REM **Product level. Settings include RTOOLS, R2V, RCAD and RCADPLUS.**
ProductLevel=RCADPLUS
Demomode=YES
For the GTXImage CAD Series, the controlling variables are as follows:
REM **Product level. Settings include ICAD and ICADPLUS.**
ProductLevel=ICADPLUS
Demomode=YES
|
